cement mortar spraying equipment

Automatic wet mortar sprayer is a kind of machinery to spray mortar spray mortar into the surface of the wall. The material is transported to the front end by the screw, and through the blow up of high pressure gas, the material is evenly sprayed to the surface of the object. Steps and requirements of cement mortar sprayer; 1. Before the start of each class, the oil pump is injected to the transmission parts in several times. After switching on the power, the main motor is checked to check whether the rotation direction of the rubber screw is the same. If it is not consistent, it is necessary to change the power supply phase line. 3, connect the conveying hose and sprinkler head, add the clean water 5L to the hopper, start the motor, pump the clear water out, and put the wet hopper, the pump body and the conveying hose to stop most of the water after it is pumped out. 4, add putty or paint to the hopper to start spraying (first start the air compressor and open the wind valve). 5, the hopper is strictly prohibited under the condition of no material and water. 6, after the work is finished, drain the remaining materials inside the hopper, and pour enough water into the hopper, clean the hopper, and turn on the pump and clean the hoses and sprinklers until the pump is clear, so that the remaining materials will be solidified in the hose, and the hoses and sprinklers will be blocked. 7, the shutdown time is too long, wipe the cement mortar spraying equipment clean, and unload the supercharged screw, oil, proper custody, reinstall when use. 8. The pressure of the pump is insufficient in the work, and the turbocharged stator bolt can be adjusted or the pressurized rubber sleeve and the supercharged worm can be replaced. 9, before spraying, spray area should be infiltrated with water. When spraying, the sprinkler should be vertical as far as the spray surface (the distance can be adjusted according to the spraying effect), and spray evenly and evenly, and coordinate with the leveling process. When the wall is too dry or a long time after spraying, it will seriously affect the leveling effect, and the process should be changed.